![]() If not, repeat the steps again until it works.Īs with the TV set up, you might need to do these steps more than once, but it will be worth it.Ĭongratulations - you’ve set up your universal remote control! If you’re still interested in doing more tasks on your own, take a look at the other DIY articles in our Resource Center. After this is done, press the Stop button to save the code for that device, and check all functions to make sure they are working.If the component turns off that means the control already found the code for it to pair with your device. Step 5 : Press the TV Power button on the remote. Step 4 : The LED should flash green twice when the code is entered. Step 3 : Enter the universal remote code from the TV codes lookup tool using the number buttons on the remote. Once you’ve done this part, use the power button on your remote control to scan the code needed to set up your device. Step 2 : Press the Setup button on your remote until the LED at the top of the remote changes from red to green.The Power button light must stay on… if it does not, repeat steps 2 and 3. Release both the Power and the device button.Most of the time this takes up to five seconds. Press and hold the device button at the same time as the Power button, until the light turns off and on.Wait for the light on the remote to blink and then stay steady for you to follow the next step. Press and hold the button that matches the device you are pairing.Manually turn on the device you want to set up, making sure that your RCA universal remote is aiming towards it. ![]() Here are the instructions you need to follow. Say, for example, DVD, streaming device, Blu-ray, etc. The first thing you need to make sure is that your universal remote has an option for it. Programming your RCA universal remote for other devices
0 Comments
Leave a Reply. |